How to Use this Remote with our Microwave Sensor:
• Permanent ON/OFF
Press button (1) to select permanent ON or permanent OFF mode. Press button (2)/(4) to resume automatic operation.
The mode will change to AUTO Mode after power failure.
• Reset
Press button (2), all setting go back to the default settings:
Detection range: 100% Hold time: 1min Stand-by period: 5 min. Stand-by dimming level: 20% Daylight sensor: LUX disable
• Shift
Press button(3), the LED on the top left corner will flash to indicate mode selection. All values / settings in RED are valid for 20 seconds.
• Auto Mode
Press button (4) to initiate automatic mode. The sensor
starts working and all settings remain as before the light was switched ON/OFF.
• Semi-auto Mode
1. Press button (3) Shift (the red LED is on for indication),
2. Press button (4) to initiate semi-auto mode. The fixture
is manually on by push-switch and automatically off in semi-auto mode.
• Power Output
Press button (5), the light output shifts between 80% and 100%. NOTE: The function of “Sensor off” and “Twilight” are disabled.
• Brightness +/-
Press button (6) to adjust the light brightness between 10%~100%.